C-24.2, r. 35 - Regulation respecting special permits

Section 3.2 Disposition versions

2012-09-01

3.2. An applicant must, in addition to the information prescribed in section 3.1, furnish the following information according to the category and class of the permit applied for:

(1)  for a Class 1, Class 2 or Class 3 specific permit or for a Class 7 permit, the overhangs and the dimensions of the vehicle, including the load and equipment;

(2)  for a Class 1 specific permit or for a Class 6 or Class 7 permit, the nature of the load;

(3)  for a Class 4, Class 5 or Class 6 permit, from 28 February 1994, a statement to the effect that the drivers working for the applicant are familiar with the Répertoire des ponts et viaducs faisant l’objet de limitations de poids published by the Ministère des Transports du Québec;

(4)  for a Class 4, Class 5, Class 6 or Class 7 permit, the type of vehicle;

(5)  for a Class 4 or Class 5 permit or for a Class 6 general permit authorizing a vehicle whose load limits are provided for in Schedule 1 to travel on a bridge where a sign prohibits travel by outsized vehicles, the licence plate number; for a Class 1 specific permit or for a Class 6 or Class 7 permit, the licence plate number of the semi-trailer, trailer, crane, special mobile equipment or single unit vehicle;

(6)  for a Class 4, Class 5 or Class 6 permit, the minimum width of the tires, the number of tires per axle, the minimum spaces between axles and groups of axles, the minimum capacity of the tires per axle and the capacity of the axles controlled by the steering wheel;

(7)  for a Class 6 permit, the axle load and the total loaded mass;

(8)  for a Class 4, Class 5 or Class 6 permit and for each axle:

(a)  the type of axle;

(b)  the type of suspension;

(c)  a statement to the effect that the mass that can be measured under the wheels of each axle that is part of the groups of axles that have the characteristics of a tandem, triple or quadruple axle is distributed equally at all times, within a margin of 1,000 kg;

(9)  for a specific permit of any class, the point of origin, the destination and the roads used;

(10)  for a Class 6 or Class 7 general permit, the roads used and, in the case of repetitive transport of the same nature and for a single specified route, the point of origin and the destination;

(11)  for a Class 6 permit, where applicable, an indication as to whether the application applies to the outward trip or the return trip and, in each case, an indication as to whether the vehicle is empty or loaded;

(12)  for a Class 7 general permit, the dimensions of the load that make the vehicle outsized, where applicable.

O.C. 1605-93, s. 5.